SIMPLE METHOD of CUTTING AND SEWING SHORT PALAZZO USING HAND STITCHES OR SEWING MACHINE @fonexsignature 10% payout to skillshare

![IMG_20210907_140648_9.jpg]()

Hello my lovely friends of skillshare community, is a thing of joy to see that you are doing well and safe.

Today I'm delighted to share with you how i can used half yard of fabric to make short palazzo,you may used hand stitches but since I owned sewing machine I decided to used it.
This short palazzo can be done within a view minutes or more depending on how fast you are.

First of all I take my measurement, it involves;-

• length - 20

• waist - 36
• hips -41

• laps -28

Round knee -15

Crotch - 9 1/2

To set the ball rolling

IMG_20210824_105535_5.jpg

This is my material (strips vintage fabric)

First of all I have to look at the design of my material,and my own is strips so I have to position it this way as you see in the picture above.

Front Pattern:-

I fold my material into two and begin to mark my measurement on the table.
To determine my crotch I used my waist measurement and divide it by four (36÷4=8 1/2) then I add my seam allowance to make it nine half inches (9 1/2") as you see in the diagram.

IMG_20210824_110632_4.jpg

I place my tape to where I have 9 1/2" and
mark my crotch, mark my hip point and kneen point.

NOTE; in cutting and sewing of trousers is only the waist and hip measurement will be divided by four while from lap to knee will be divided by two.

Since I fold the material into two I mark

waist 9 1/2"
Hips 10 1/2"
Knee 7 1/2"
After the marking i used hand sketching to draw my crotch from the waist line to crotch line then I used ruler and draw from the crotch line to the finishing line and cut it out.

IMG_20210824_111136_3.jpg

Back Pattern:

IMG_20210824_111010_6.jpg

After cutting the front pattern I place it on the remaining material to cut my back pattern and I decided not to add back allowance because it's a stretch material then i cut it out, now am done with my cutting I begin to sew
First, I stitch the crotch both front and back, I do my shaping and bend the kneen using 2inches.
IMG_20210824_112056_5.jpg
IMG_20210824_113255_5.jpg

IMG_20210824_115731_2.jpg

Finally, I cut my waist band by 4inches and fold it into two and place on the bad side and stitch then I turn it to the good side and stitch it. my short palazzo is ready for wearing.

IMG_20210824_115731_2.jpg

You can be wearing it inside the house or in the morning and also in the kitchen
Thank you so much going through my post

Sort:  

This is beautiful, it looks good on you, thanks for sharing the steps and how to get the measurements

Thank you very much dear