How Do You Properly Maintain and Store Your Pool Cleaning Robot

A pool cleaning robot is a valuable tool for keeping your pool clean with minimal effort. Like any other piece of equipment, it needs proper care to keep it working for a long time. By following some simple maintenance and storage practices, you can keep it in good condition and avoid unnecessary repairs.

This guide explains how to clean, maintain, and store your pool cleaning robot so it performs at its best every time you use it.

Clean the Filter After Every Use

After each cleaning cycle, remove the filter from the robot and wash it thoroughly. A dirty filter can reduce suction power and cause the robot to miss debris.

1.Switch off and unplug the robot before handling it.

2.Open the filter compartment and take out the filter cartridge or bag.

3.Use a hose to rinse off all debris. Avoid using harsh brushes that can damage the mesh.

4.Allow the filter to dry before placing it back in the robot.

Cleaning the filter regularly prevents blockages and keeps the water flow steady.

Rinse the Exterior

Chlorine and pool chemicals can stick to the robot’s surfaces and cause wear over time. After each use, rinse the exterior with fresh water.

•Remove the robot from the pool and set it down in a shaded area.

•Use a low-pressure hose to rinse off all parts.

•Pay attention to the wheels, brushes, and tracks where debris can build up.

This simple step helps extend the life of the plastic and rubber parts.

Check and Replace Worn Parts

Just like any mechanical device, some parts of the pool robot will wear down. Brushes, belts, and tracks are common parts that need replacement after extended use.

If you use a Dolphin pool robot, you can easily find repuestos dolphin for worn-out components. Keeping a few spare parts on hand lets you make quick replacements without delaying your cleaning schedule.

Inspect the brushes for frayed bristles and check the belts for cracks or stretching. Replacing these parts in time helps maintain cleaning performance.

Avoid Tangled Cables

The power cable can get twisted during operation, which may reduce the robot’s range or cause strain on the connections.

•Lay the cable out straight before starting a cleaning cycle.

•After use, untwist the cable and coil it loosely.

•Store it separately from the robot to avoid kinks.

Proper cable management reduces wear and prevents power loss issues.

Store in a Cool, Dry Place

When not in use, keep your pool cleaning robot in a shaded, dry area. Direct sunlight can fade plastic parts, and excess moisture can cause corrosion on metal components.

•Avoid leaving the robot in the pool when it is not operating.

•Use a storage caddy or shelf to keep it off the ground.

•Keep it away from chemicals and salt storage areas.

If you live in a region with cold winters, store the robot indoors during the off-season.

Conclusion

A pool cleaning robot can save you a lot of time and effort, but it needs proper care to keep working efficiently. By cleaning the filter, rinsing the exterior, replacing worn parts, and storing the robot in a dry, shaded place, you can extend its life and avoid unexpected breakdowns.