SLC s21w3-Basic layout for men's shirt

khursheedanwar (75)in #burnsteem25 • yesterday

Basic step by step men's shirt layout

Here I am using a step by step approach for describing basic steps for men's shirt layout,although it was not easy for me that's why I am sharing it at weekend after practicing it for many times!
Let's start!

Step 1: Draw Center Front Rectangle

I simply take a paper and I draw vertical line at cardboard and my first step was to make a rectangle (4 cornered square) and label corners of rectangle with points ABCD.

Step 2: Measure Chest Circumference

In my second step J measure 1 by 4th of over all circumference of chest by starting my measurement from top of rectangle I made and then I added two centimetres by drawing a horizontal line.

Step 3: Measure Neck Circumference

After that it was the time to measure 1 by 6th of overall circumference of neck. After that I minus 1 cm to give it an allowance.after doing that it was the time to draw curve the line starting from point A and moving towards D.

Step 4: Define Chest and Neck

You can clearly see in the picture I have shared that where is point a and where is point b so if we combine both of them then it will be AB point so from that point we need to take measurement of 1 by 6 of circumference of neck. After that we will give around 2 cm allowance and will mark that specific point.

Step 5: Determine Back Width

Now this is a time of measurement of 1/2 of width of back from AB points.

Step 6: Create Shoulder

Next step was for creating shoulder in which you can see that from line number 5 I have measured around 1 cm and by keeping in mind the intersection I draw a straight line.

Step 7: Define Armhole

Now you can see that there is line number 8 from which I take a measurement of 1 cm towards down so that I make create a curve.

Step 8: Define Drop Shoulder

This is really very important to define drop shoulder so for this purpose I have drawn straight line for meeting intersection of arm hole curve.

Step 9: Create Slant

I need to create a slant now so for that purpose I keep in mind seed so that I may take measurement of 1/2 for creation of curve line.

Step 10: Add Pocket

For adding pocket I measured a distance of 3 cm from line number 5 and 10 cm from length side.

Step 11: Add Button Allowance

It is always important to add button allowance so so this purpose I have added 3 cm folding from point a to b.

Step 12: Verify Fit

After that this is last step of verification in which I verified that this front layout seems to be fine or not so it seems fine to me by following step by step procedure.