-=Miner Repair=- Replace your PCIe Power Connector on Antminer S9 R4 D3 S7

in #antminer7 years ago (edited)

IMG_1334.JPG

IMG_1335.JPG

This is how I removed the connectors.
Excellent description how-to do it.

[QUOTE]
You have to get a pre-heater. Aoyue 853+ or better at minimum. Don't use a super big soldering iron, you will just burn the vias before you remove the part.

Cut the back three prongs on the connector before you start. That way you are removing them one at a time, not six at once.

And the super magic secret: Tin the leads with lead/rosin solder. This will lower the melting point of the crap ROHS solder a lot and make removal easier.

Use very good flux. Flux cleans connections and transfers heat.

Once off, use the solder wick to take up all the solder. Flux is good.

Clean everything up before installing the new one.

Flux the ends of the new plug before inserting. That way the new solder will flow.

Heat the board again then solder the back three pins.

Flip the hot board over in your lap and solder the front three.

Oh wear thick pants.

Clean everything up and admire your work.
[END QUOTE]

*** From lightfoot https://bitcointalk.org/index.php?topic=1597639.msg23620105#msg23620105

IMG_1338.JPG

This is a Molex Mini Fit Jr. serie 45558

Molex_45558-0003.jpg

PDF here :
http://www.farnell.com/datasheets/2214312.pdf

You can find them here for 0.79$ each
https://tinyurl.com/y8qhwmhd

Sort:  

Congratulations @qctechno! You have completed some achievement on Steemit and have been rewarded with new badge(s) :

Award for the number of upvotes

Click on any badge to view your own Board of Honor on SteemitBoard.
For more information about SteemitBoard, click here

If you no longer want to receive notifications, reply to this comment with the word STOP

By upvoting this notification, you can help all Steemit users. Learn how here!

I have been really struggling trying to desolder mine as well. I burned the pcie connectors on mine just like in the picture above. By any chance do you have a video of how you removed the solder? How long should it take to remove the solder from a single hashboard? I worked one on for hours the other night and didn't even finish. It has been very difficult, to say the least to remove the solder. I will say, that I don't have a preheater though. Do you thin that's the critical step that I'm missing?